Charles Schofield asked 2 weeks ago
You can find out more via heating controls supplier.
Noise is a real factor when deciding between the two. A side-entry valve introducing water above the surface tends to produce more splash and a higher-pitched fill sound, which shows up as a complaint on quieter properties such as flats with shared walls. Bottom-entry valves that fill below the surface are noticeably quieter, and swapping a noisy side-entry unit for a bottom-entry equivalent is a common upgrade even where nothing has technically failed.
Measuring before ordering saves a return trip: the thread diameter of the existing lever body, the distance from the lever mounting to the flush valve connection point, and whether the arm needs to sit above or below the water line all affect which replacement will actually fit. A lever bought to the wrong thread size will not seal against the cistern wall, however well the rest of the job goes.
Top-fix hinges solve exactly that access problem by using a bolt and http://www.plumb2u.com a quick-release or turn-to-tighten fixing that can be adjusted entirely from above the pan, with no need to get underneath at all. This has made top-fix the standard choice on most new soft-close seats sold in the last several years, and it is usually the easier option to specify when the underside of the pan is difficult to reach or when the original fixing has seized.
A close-coupled cistern bolts directly onto the back of the pan with no visible pipework between the two. Because the outlet on the cistern base sits directly above the inlet on the pan, the flush valve or siphon needs a shorter outlet and often a rubber doughnut washer to seal the joint rather than a length of pipe. Fill valves on close-coupled units tend to be shorter in the body too, since there is less depth inside a compact tank.
The third check is worth doing before assuming either fault: isolate the water supply to the cistern, remove the fill valve, and inspect the seat and washer directly for scoring, grit or mineral buildup, particularly in hard water areas where limescale narrows the valve opening over months. A valve that looks visibly worn or scaled at the seat is the straightforward fix. A valve that looks clean and undamaged but the noise persists points more strongly toward mains pressure as the underlying cause.